The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
5508 AP Allow only certain AP's to have dual radio's enabled. I have a device(printer) that operates on 2.4.wifi. I would like to enable the nearest(one) AP to have 2.4 and 5.8 operating. 5508 running 8.5.140 currently. I am trying to move every...
Good Afternoon,One of the departments in our hospital is wanting a Cisco CP-8841 telephone on the second floor of their building. The network switches on that floor are not ready to support VOIP yet but the ones on the 14th floor are. Does any...
Hi EveryoneI have a group of users who are in a hunt group and they want to have a night service enabled. I asked them would they like to have TOD routing enabled and they said no because some days they leave early and some days they leave late and TOD ro...
I want to display the first name last name of the user using the IP phone in ArabicUseful informations:- phone model: sip phone 7841- arabic is already loaded on phone "menu only"- Software and hardware: version CUCME 12.2 on ISR 433...