The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
is the Cisco ATA192 supported on CUCM version 11 or 12 ? i see the ATA192 Multiplatform datasheet mention that. it does not work with Cisco call control systems.i need ATA with 2 port RJ45 which support on CUCM 11 or 12.please help.
Hi, Has anyone tired connecting a Cisco Room Kit to a Surface Hub 2, with the Surface Hub only acting as a display. I don't see any issue with that since the Surface Hub will only acting as an output display and the call will be dialed via the ...
I can not import new SSL in our webex meetingadmin site, I have import many time but it still the old ssl, which one is coming out of date soon.But when I try to export SSL form SWMS system, it is an new SSL that I have import success.I try restart server...
Hello,I need somebody to help me how to create two reports in cuic 11.6 in the following fields Report 1RouterCallKeyDay (int ,not null)RouterCallKey (int , not null)CallTime (datetime)CLID (varchar (32) , null)QueueTime (int , null...
hi all i have problems with incoming calls from other ip phones to 8851 cisco ip phone with Newrock OM series ip pbx as the main pbx server!!outgoing calls from my 8851 ip phone are ok!!i tried reinstalling firmware but that wasn't helpful!i'm curren...