The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Hello Everyone, I 'm looking at the output of show call active voice compact of recently installed CME. I noticed I have ton of calls generated randomly. Can anyone plz explain why I have this behavior? Temp-VGW-01# show call active voice compac...
I have been tasked to retrieve caller ID from internal callers which was a sucess for all extension thanks to Mike who helped me. Now an add on is required because they want to be able to distinguish between callers based on caller's Mobile/Extension and ...
Hi All I have a CME on 3925 running ISO 15.5, and the CUE is 8.6 from sip trunk to CUE Voicemail. the call comes in after 2 rings it should go to voicemail, but the call drops for a sec then it carries on ringing again. no supplementar...