The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Estimados buenos días, Necesitaría saber como es el lujo de llamadas desde cualquier interno que este registrado en CUCM con un interno que pertenezca a un agente en UCCX.Yo tengo actualmente CUCM 11.5 y UCCX 11.6Tengo un Route Plan Report (Patt...
Hi Community, I have a fax line connected to an FXS voice gateway port. The caller ID from the ports to external number only shows the 4 digit number of the CUCM route pattern, not the full 10-digit DID. My provider will be blocking...
Hi All, I am having this issue where I am unable to create/move any new folders under 'Reports > Stock'. But there are custom folders already created. I can only create a new folder under 'Reports' directory, I have given the administrators g...
CUCM and VCS are in two different network and are connected via MPLS. We created the SIP Trunk successfully and also able to establish the call. However we are not getting any media. We also raised it with Cisco TAC SR 687417153. We want media to travel v...