The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Within the last 48 hours we have noticed the CPU averaging about 40 to 60 percent with peaks 80 percent ... It's random but happening on them. Configurations are mirrored. They are registered to the VCS Control also. Th...
Looking for suggestions for a 'War Room' type Webex meeting space where a personal-like room is always available and has the ability to notify and call all required attendees. Hoping to maintain all functionality in cloud so the service is available...
I unfortunately do not have access to O365 and have had to use my University credentials to download Outlook, Word, etc. When downloading Webex I cannot connect to a meeting and it does not pull Outlook calendar. I tried downloading the scheduler but it w...
In our DL set up - we have two SX80 codecs connecting with a WebEx Plus codec. We are generally connected Monday through Friday from 8 am to 5 pm. However, in the past few weeks we have video glitching at the site with the WebEx Plus codec and...
Hiplease check the below Quantity of licenses and versionBasic Licenses = 10Enhanced Plus = 13System version = 126.96.36.19900-11 find the attach estimate and let me know provided addon licenses are right.