The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Hi Folks, I have implemented MRA via expressway and apple push notification service for Cisco jabber. It works well however I have few queries: 1) In jabber client on iPhone I can see internal CUCM and Unity connection IP address under phone ser...
New to UCCX scripting, but I wrote and entire medical eligibility UCCX IVR app and I'm stuck on this one thing only.What do you use in the script to execute this webcall. "http://192.168.5.5/logEnter.php?LOG_ID=2222"This is a confirmation number add to th...
OK, I know it is simple and I am just missing it, but here is my scenario: Production CUCM 12.5 with IM&P using DNS SRV RecordsProduction Unity ConnectionJabber 11.6 Lab CUCM 12.5 with LAB IM&P, no DNS (Same Network as production)Test Ja...