The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
We have CCM 11.5 along with gateway 2811 cube, C2800NM-ADVENTERPRISEK9-M), Version 15.1(4)M10 configured as CUBE gw. All sip.I had similar issue https://community.cisco.com/t5/unified-communications/redirected-calls-doesn-t-show-external-phone-mask-a...
Hello,I hope I'm asking this question in the correct forum.We are looking at using Cisco WebEX for our telephony solution (very small SMB). We were just wondering if Cisco is using Cisco Unity Connection as the voice messaging service??? We we...
Guys, can someone please help me out I just wana have the Call.CallingLineID on my routing script, i know the reservation call passes through the script but it does not have any ANI to it, is there a way i can get that onto my script?? Any help or cl...
Hi, we recenlty integrated our AD to call manager, however a we left he Phone number attribute to telephone. this has messed our corporate directory. we need to change the phone number attribute to IPphone now and perform a sync, we are un...