The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
I have a Cisco 8961 running sip8961.9-4-2SR4-1 firmware. On my config file I have Bluetooth and the USB ports enabled. When I plug in a USB device it says that the port is disabled by the administrator. When I try to find Bluetooth in the setting I c...
I have a Cisco 2911 router with the UC license running IOS c2900-universalk9-mz.SPA.157-3.M.bin abd a SM-ES2-24-P switch installed into it with 5 IP phones connected to the switch. Please note that this is a Service Module switch and not an external switc...
We have registered Webex Team (Windows )with CUCM.My Queries are following:1.Shall CUCM corporate directory work on Webex Teams,just like it works on Cisco Jabber.2.How can we retrieve voicemail on Webex Teams ,just like we do on Cisco Jabber.
Hi, It's nice that Expressway supports certification renewal with ACME / Let's encrypt. Sadly even the current 12.5.5 is still using ACMEv1. This is an old version and is being replaced with ACMEv2 since 2018.I've just had an issue where ACMEv1 didn'...
Hello, I'm running UCM 18.104.22.16800-16 and a subscriber node has stopped to authenticate users. LDAP authentication is configured but even local users fails authentication. There are no authentication attempts in UDS logs with enabled debug leve...