The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Hello community, We have this very odd issue:Incoming call from external number to internal extension that is forwarded to another external number is connecting, but has no audio.Phone A (any external number, but in this example +359889610844) dials ...
Currently using CISCO express across three sites and I am based on one site I use CISCO supervisor to listen in on calls but can only listen in to calls received into my site. I really need to listen into calls into all sites. Any ideas???
Hello AllI would like to set up a CUCM/CUC/Presence home lab to understand things in deep such as registering SIP gateways, route patterns, etc. I have brought a couple of 2911's, 3850's and IP phones and I7 8th gen 16GB laptops for lab sakeCould someone ...