The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
Hello I'm looking for someone who could confirm if JABBER in its current version could be compatible with Windows Terminal and work in a TSE environement ? As I could find on the Jabber current datasheet, Windows terminal is not listed as ...
Hi Guys,Recently I've been digging into some call records to generate some reports. But, on callingPartyNumber from CDR records, some of the values are "Unknown". Is this some kind of bug or it's a missing info received by the CM? My CM is 11.5.Thank...
Running CISCO WEBEX Room 70 Dual G2 with Ce9.8.x firmware. Problem is dual display input. The Computer input one and the display is mirrored. Is there a setting to extend display between the two monitors on the 70??? Want to show a vi...