WIth Cisco Unified Contact Center Express 8.0, the Cisco Agent Desktop (CAD) Supervisors keep getting the pop up error "Supervisor has failed to start device monitor on" when they try to do the desktop monitoring.
Make sure that
All services in UCCX are "in service"
Span to PC port is enabled on all agent/supervisor phones
The option to Advertise G.722 codec is disabled
Ran PostInstall on supervisor and agent PC and pointed Voip Monitor IP to their respective local NICs
Run a Route Plan report on the UCCX DN and make sure that only one instance is shown. This is because only one device can be associated with the UCCX DN or the system may look for an RTP stream with an incorrect MAC ID. The exception would be: There is an option for HOT SEATs. This is where several agents share an extension but this extension will still have to remain on a single device.
Note: In some cases, when Extension Mobility is set up and the agents are logged into Extension Mobility and the CAD, the Device Profile and the actual phone may appear in the Route Plan Report.
Open the Desktop Administrator and ensure the Desktop Monitoring Option is selected for the appropriate agent. Also check the selected VOIP Monitoring server.
Check the NIC Binding. Ensure the NIC you are using for the capture is the primary in the NIC binding order. Disable the wireless NICs if any.
Disable the Windows Firewall in the services option of the desktops for the Agent and Supervisor.
Disable any antivirus that you may have on the desktop. This may indicate there is a port blocking issue with the application. In some cases, we would need to add rules or exceptions for firewalls or applications not to block certain ports.
If all the above fail, download a common program for capturing traffic. Once installed, place the agent on a call with the UCCX Extension, select the proper NIC and see if there is an RTP stream present in the capture. If there is, then the phone is working properly and the RTP stream is being delivered to the Desktop. If not, then we would look on the phone side to determine what the issue may be.
Hi I am deploying webex hybrid calendar for exchange on premis using the expressway c. In 6 months time the client will be moving mailboxes to 0365. I would rather integrate directly to 0365 and decom the expressway c. Is this possible- ...
We're looking for a solution that we can use as an Training tool. Ideally, we'd like to be able to have employees launch a WebEx session, login to a Virtual Desktop and complete the training. Our instructor would like to be able to view the tr...
Hello All. I am working on an upgrade from PCCE 11.0(1) to 11.6(1). I read the following blurb in a CVP licensing document: Beginning with Release 11.5(1), the IVR service that was part of the Call Server is now part of the VXML Server. T...
I'm attempting to bulk add about 1,200 local end user profiles but continue to get the below failure: -----------------Warning :LDAP Sync status is enabled.Some fields cannot be updated.Password should be specified either in CSV file or default crede...