Because the PRI is backhauled (transported) to Cisco CallManager in normal conditions, and when a gateway loses connectivity to the Cisco CallManager, the PRI Q.931 has to terminate locally on the IOS . Therefore, the gateway has to remove backhaul from the D-channel and reset the D-channel so that the active call is dropped.
When the gateway rehomes to Cisco CallManager, the gateway needs to backhaul the PRI to the Cisco CallManager. Also, when the gateway tries to configure backhaul to the Cisco CallManager, the D-channel needs to be reset and the active call is dropped. Therefore, MGCP PRI backhaul cannot support call presevation during fallback to the SRST or rehoming back to the Cisco CallManager.
We were in the process of upgrading PCCE from 11.6 to 12.0 and what we found during CUIC upgrade that it fails and when we checked in the replication , it says replication_not_setup on both cuic publisher and subscriber nodes.Please advice if anyone has o...
Hi thereI wrote a Webservice for my customer and a simple Webinterface. I added now a custom tab for it and it works fine internaly (and VPN). But over MRA it is not working: Jabber:Page failed to load.URL: http://xxx.contoso.int/index.htmlError...
When agents make manual outbound calls , the skill group is displayed as CUCM_PG_1.Cisco_Voice.defa in Livedata.Is there a way to change / mask the skill group to some other name so that supervisors can view in CUIC as manual outbound.
i receive the below message every days ,what is the meaning : Microphone Overloaded Error::State=unacknowledged;Component=........ ................ .......... ..........;Description=Microphone(s) overloaded. More Information: OverloadedMicrophone=2