This problem affects the Cisco 3745 gateway router, which has several Foreign Exchange Station (FXS) ports installed. When the FXS port is used to make calls toward the Cisco CallManager, the calls fail, and the caller hears a busy tone. However, calls made from the IP phones to the FXS port work as expected.
Normal Cisco IOS Software operation is to hunt through configured dial-peers in a top-down fashion. So when the FXS port goes off hook, Cisco IOS hands over voice port call control to the default H.323 gateway or session operation. Since the router is not able to make a match on any digits dialed by the handset, it plays the re-order tone and calls fail.
An inward call from the IP network matches on the dial-peer that has the application mgcpapp commandconfigured, and can be sent out of the voice port.
To resolve this problem, perform this procedure:
Make sure the application mgcpapp command is configured on the applicable port.
Re-order the Plain Old Telephone Service (POTS) dial-peers to list the Cisco CallManager-generated dial-peers first in the dial-peer list. Ensure that inward and outward call control is handled by the correct dial-peer under Media Gateway Control Protocol (MGCP) control.
After the MGCP is reset on the gateway (issue the no mgcp andmgcpcommands), make a few test calls.
Ideally, calls are possible in both directions through the FXS port now.
Calling from Cisco phone to any mobile phone(PSTN)If mobile user didn't pick call, then Cisco user cant hear announcement/VM of that mobile service provider.When calling from my mobile to that mobile user, I can hear the announcement/VM. Ca...
Hi there everyone! I'm trying to setup the 8865 multiplatform with a standard SIP provider (Telnyx, in this case). I think I bit off more than I can chew. I've managed to get the phone to register briefly, but then it'll lose registration. All...
I have Webex site with Hybrid calendar and call services enabled for Cloud registered Room Kit's, and when dialing a complete URI to any non webex.com or cisco.com domain the call fails. Troubleshooting it I saw the call routing into the Expressway'...
I've been doing some updates at several remote locations and somehow I broke Caller-id. We used some older 2811's as H.323 gateways as well as routers on a stick, during the process I updated the IOS from 12.4 to 15.1, increased the RAM, PVDM2, and added ...
Hi all, CUCM 11.5 I did my best to search Google, then signed up here searched and read a lot of discussions but could not find something solid that I could go on outside of creating new CSS, PT and then doing transformations and/or translations...