Incoming calls to CTS endpoint have audio only and no video
An incorrect CUCM config:
The most common reason for this is bandwidth issues and/or not disabling "Speakerphone" and "Speakerphone and Headset" on Phone Device Profile.
A less comon cause of this same issue is configuring MTP “Media Termination Point Required" on the codec device profile under the "Protocol Specific Information" section. Verify this is unchecked.
For issues with audio only and no video on a Telepresence call there may be one of several common issues with the CUCM configuration:
797x phone config (Device•àPhone)
Product Specific Configuration Layout
Make sure that the following is checked:
a) Disable Speakerphone
b) Disable Speakerphone and Headset
If these are not done the phone could pick up before the codec causing intermittent audio/video issues
Bandwidth issues (VERY common !!!)
Check which Device pool the phone and codec are in from the Device profile. CUCM Device----->Phone--->Device Info
Next go to System--->Device pool and check the “Region” and “Location” and check the settings
Note these settings, then check System--->Region and verify that interregion BW settings for Video and Audio are set to “Unlimited”
Do the same for "Location" under System--->Location verify that Video Bandwidth is set to "Unlimited"
Note: A Location has to be configured even if using "Hub-none" which is tied to the Device profile which also needs to be set to Unlimited for Video
MTP (Media Termination point Required) on codec device profile configured
Less comon but can cause the same issue is configuring MTP “Media Termination Point Required" on the codec device profile under the "Protocol Specific Information" section. Please make sure this is unchecked !!!
Hi,I have just upgraded an 11.5 deployment of CUCM, IM & P and Unity Connection servers from 11.5 to 12.5.The operating system used by the virtual machines changes from Red Hat Linux to CentOS 7.I have tried to change the guest operating system on the...
If a remote destination is calling in to another desk phone on the same cluster (PBX) the caller ID from the attached directory number. If you call to another cluster it will just show "WIRELESS CALLER". I am wondering if there is any solution so all clus...
Hello...I have an issue with sound/voice outgoing and incoming call.Use 2 ISPs, the first ISP uses E1, and the other uses SIP. When trying to make an outgoing call, at first there's no problem with sound and hear what they said.But, in the middle of ...
I have an existing number of 3200 that I want to forward to a System Call Handler number of 5847. I can dial 5847 and all the prompts work with no issues. But when I add the 5847 number to the call forward of 3200, all I get the voicemail message. &n...
Hi Experts, I am a bit confused to understand the queue time and the ring time in the CCX. I have configured the queue overflow as shown below. Please correct me if I am wrong here; Every select resource step has the same timeout...