The clocking configuration appears to be correct. However, the show controller command shows a repeating clock slip on the E1 or T1 interface, as shown in this example:
Router#show controller e1 0/0 E1 0/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20020812, FPGA: 11 Framing is CRC4, Line Code is HDB3, Clock Source is Line. Data in current interval (97 seconds elapsed): 0 Line Code Violations, 0 Path Code Violations 4 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 4 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs Total Data (last 14 15 minute intervals): 1 Line Code Violations, 4 Path Code Violations, 425 Slip Secs, 0 Fr Loss Secs, 1 Line Err Secs, 0 Degraded Mins, 427 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
If a single port E1 and T1 Voice and WAN Interface Card (VWIC) is physically in WIC slot 1, and no other VWIC modules are installed, it is referred to as WIC 0. This is the case even though it is still technically on slot 1. The Cisco IOS Software configuration also refers to it as controller t1/e1 0/0.
To resolve this common configuration error, ensure that the network-clock-participate command refers to wic 0, rather than wic 1.
This is an example of the required configuration for a 2600, with a single VWIC physically located in slot 1:
Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#network-clock-participate wic 0 Router(config)#network-clock-select 1 t1 0/0 Router(config)#^Z
To confirm the system clocking, issue the show network-clocks command, as shown in this example:
Router#show network-clocks Network Clock Configuration --------------------------- Priority Clock Source Clock State Clock Type 0 T1 0/0 Good T1 5 Backplane Good PLL Current Primary Clock Source --------------------------- Priority Clock Source Clock State Clock Type 0 T1 0/0 Good T1
Hi Folks, i'm a first time poster, so go easy! At work we have an analogue (POTS) gateway device which is being developed for us to interface to our CUCM platforms (v12.5.1). It provides analogue to SIP conversion and SIP registration as a 3rd Party ...
Having a strange problem on CUCM 12.5 where calls to existing numbers return 404 not found. History. We had a pilot number that was removed from the system. The number lives in an avaya system outside of Cisco. The call ...
Hi,I wonder if someone could clarify a couple of points. (1) What is the effect of the configuration line "midcall-signaling passthru" on it's own, not followed by any further options. Is that any different to removing the line altogethe...
HI guys, we have a CUCM Cluster 10.5 and we would like to migrate to an existing and operational CUCM 11 Cluster. Can the PCD (Prime Collablration Deployment) tool be used for this? Or PCD can only be used to migrate to a new cluster?CUCM cluster mig...