Hello all. instead of using a lod of dial peers in ym SRST MGCP fallback config I was thinking of using only these twovoice translation-rule 1rule 1 /^.*\(.....$\)/ /\1/ !voice translation-rule 2rule 1 /^.*$/ /90\0/!!voice translation-profile PSTN-In...
Hello,I installed UCCX 12.5 SU1 and try to integrate with CUCM 11.5 SU9 that is supported as per Cisco Matrix but I found error failed unknown Host AXL foundI exchanged CUCM Cluster tomcat certificate to UCCX & Checked Axl on CUCM and running fine the...
Hi All, I need to change the line partition of several phones based on a IP subnet. BAT is rubbish. I'm quite sure someone has done it and I suspect its a CLI command but I'm not that good with that sort of thing. Any ideas folks? ThanksPaul
Hi Pals,I am trying to form a cluster of 1, of an expressway following the this guide.https://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/config_guide/X12-5/Cisco-Expressway-Cluster-Creation-and-Maintenance-Deployment-Guide-X12-5.pdf T...
Learn: How to configure Cloud Connected PSTN with Webex Calling
CCP Provider Name
Product Home Page Link
Webex Calling Customer Region
Countries Supported by Provider
Free Trial Link
Contact Provider Link
FR & LU