This document covers the procedure for configuring Speed-dial and Abbreviated dial setup. This procedure is applicable to Cisco Unified Communications Manager Version 7.x / 8.x / 9.x
Configuring Speed-Dial Buttons or Abbreviated Dialing
You use Cisco Unified Communications Manager Administration to configure speed-dial buttons for phones if you want to provide speed-dial buttons for users or if you are configuring phones that do not have a specific user who is assigned to them. Users use Cisco Unified CM User Options to change the speed-dial buttons on their phones.
From CUCM 8.x onwards, system provides a total of 199 speed-dial and abbreviated-dial settings.
Speed Dial Settings
Configure these settings for the physical buttons on the phone.
Abbreviated Dial Settings
Configure these settings for the speed-dial numbers that you access with abbreviated dialing. When the user configures up to 199 speed-dial entries, part of the speed-dial entries can get assigned to the speed-dial buttons on the IP phone; the remaining speed-dial entries get used for abbreviated dialing. When a user starts dialing digits, the AbbrDial softkey displays on the phone, and the user can access any speed-dial entry by entering the appropriate index (code) for abbreviated dialing.
Note: Not all Cisco Unified IP Phones support abbreviated dialing. See the phone user guide for information
Perform the following procedure to configure Speed-Dial.
This procedure is applicable to Cisco Unified Communications Manager Version 7.x / 8.x / 9.x
Ive been asked to start morning checks. I'm looking to use rttest on the router to see the process and opctest status on the PG to sync as well as normal cpu, memory etc. Is there anything else people monitor, recommend? Thanks
I have an agent that goes into the queue, answers a phone call but then will get another call while still on the phone. I can find these instances in agent state details and it shows then as Ready>(Agent gets call)>Reserved>(Agent begins the conv...
Hi all: Have recently deployed CER 12.5.1, and all was working fine until we added a new site. This site has multiple onsite alerts (about 9) that they all state are mandatory to receive telephone and email notifications. We just tested 911 toda...
We are meeting as a group we encounter issues with video with audio when sharing recorded calls. Only one side of the conversation is played by the webex application the calls can be viewed individually and are fine. the host of the meeting can hear both ...