This document explains "How to Reset the CUCM Operating System Administrator Password ?", If you forgot the Administrator Password and unable to access the system.
Cisco Unified Communications Manager 8.0
Note: This Procedure is applicable to CUCM 5.x/6.x/7.x/8.x
Password Recovery Procedure
This section describes the CUCM OS Administrator Password Recovery Procedure
Step 1: Log in to the system with the following username and password: You must have the Physical Access to the system to peform this operation. Log in to the System via the Console with the below username and Password.
• Username: pwrecovery
• Password: pwreset
Welcome to admin password reset window displays.
Step 2: Press any key to continue.
Step 3: If you have a CD or DVD in the disk drive, remove it now, If you have media in CD/DVD it will keeps prompting you to Remove it.
Step 4: Press any key to continue.
The system tests to ensure that you have removed the CD or DVD from the disk drive.
Step 5: Once the system has determined there is No CD/DVD, It will Prompt you to Insert the CD/DVD.
Insert a valid CD or DVD into the disk drive.
Step 6: After the system verifies that you have inserted the disk, you get prompted to enter a new Administrator password.
Step 7: Re-enter the new password.
The system checks the new password for strength. If the password does not contain enough different characters, you get prompted to enter a new password.
Step 8: After the system verifies the strength of the new password, the password gets reset, and you get prompted to press any key to exit the password reset utility.
We are looking to deploy a and b side of ucce across two locations for DR. Is there a requirement to ha e a physical different circuit between the locations? It has been suggested we need a dedicated circuit between locations, even different carriers...
The last few months we have been having a lot of issues with PCP failing when trying to provision phone lines to new users and even more often there are issues when trying to delete users who have left the business.I've been on a few support calls with Ci...
Furloughed user cannot access/change/cancel meetings that were previously created.We had to add her to the app_Spark group to get her account active.User can set up new meetings as needed, but user does not have permission to cancel prior recurring meetin...
Hi there, We are deploying the Webex application during SCCM task Sequencing. The installer leverages the SITEURL command to integrate the default URL for the users. As we have multiple sites configured globally, we need to populate that ...
Recently I have been trying to improve our QoS policies to improve the quality of voice calls. I finally created a SPAN port to our SIP router and started capturing some packets. I discovered that out Jabber client voice traffic is not being tagged with t...