Within the United States, Daylight Savings Time ends (Standard Time begins) on November 7th, 2010 at 2:00am at which time clocks should roll back one hour. This document will host a consolidated list of all known issues affecting Cisco Unified Communications products for Fall 2010 DST fallback.
Cisco Unified Communications Manager
1. CSCtg50448 - DST: Update CM for Olson TZ ver 2010i
This issue affects many countries within Europe as well as several countries outside of Europe. Refer to the Release Note
for a full list of affected locations.
Table 1-1: Summary of fixed versions for CSCtg50448:
The fix for both CSCtg50448 and CSCtj75860 are included in the file ciscocm.dst-updater.2010i-2.el4.X.Y.Z.cop.sgn (where X.Y.Z indicates the version of CUCM). The appropriate patch file per version may be found in tables 1-1 and 1-2 above.
Calls to some of our registered SX10/SX20 endpoints (usually from Zoom, but not always) end up with one-way video. The media paths shown in xstatus are address of the far-end system. There does not seem to be any obvious way to get our e...
Hello, We currently have SRST's at many remote sites. Each site has approximately 5-10 POTS lines which cost $20-$40/each depending on site. I was curious if it's possible to use something like cellular instead of POTS lines for this.&nbs...
We've just went from 10.5 to 11.5, and now, we're unable to maximize/stretch-to-fit dashboards. Previous versions allowed us to do so. This issue has been duplicated across multiple browsers. Any ideas?
Hi Team.CMS is working fine calls in and out from the box, what i need to do, is to assign some kind of ownership over the space/room, like webex, so the owner can mute and also dismiss the guest user from the space. Is it possible? Regards in advanc...