Direct Upgrade Procedure for Cisco Unified Communications Manager Releases 6.1(2)—9.0(1) to 9.1(x)
This document provides procedures for performing a direct upgrade to Cisco Unified Communications Manager (Unified Communications Manager) Release 9.1(x) from Releases 6.1(2) through 9.0(1).
About direct upgrades
You cannot upgrade directly to Unified Communications Manager Release 9.1(x) from Releases 6.1(2), 6.1(3), 7.0(1), 7.0(2), and 7.1(2). For these releases, you must perform the upgrade in three stages:
1 Upgrade to Release 6.1(4) or 7.1(3) as an intermediate release.
2 Perform a direct upgrade to Release 9.1(x).
3 Virtualize Release 9.1(x).
The procedures in this document support high availability for all three stages of the upgrade.
This document is applicable to Unified Communications Manager clusters with the following environment:
• Any of the following Unified Communications Manager Releases are installed: 6.1(2) through 9.0(1).
• All of your current Media Convergence Server (MCS) servers support Unified Communications Manager Release 9.1(x).
• No changes are required to the IP addresses or hostnames for the Unified Communications Manager upgrade. If you need to change IP addresses or hostnames, you must do so in a separate maintenance window, prior to the upgrade. For more information, see Changing the IP Address and Hostname for Cisco Unified Communications Manager, Release 9.1(1).
Hello, like many people these days suddenly there is a huge surge in connecting to Jabber, Microsoft Teams, Skype, Zoom, Webex... I am trying to design a new conference room system for my customer and integrating the ability to use a software solution. Th...
I built a Blast Dial group in WebEx, only issue is it will only blast dial 3 users at a time. I discovered it was because of how many licenses we have on the WebEX. I guess only having 50 licenses will only let you blast dial 3 users at a time...
I have just provisioned two TDM VGWs side-by-side to interface to a ROLM PBX, and will provide access from the existing ROLM PBX stations to a new VoIP infrastructure, but more immediately will connect to two SIP SBCs for PSTN access. At this point I just...
I have bluetooth headphones connected to my laptop, which are recognized by Windows as an audio output (see attached). They work for all my other audio programs (zoom, music, etc...), but aren't recognized as an audio output by Jabber (see attached). How ...
Hello. I am no longer able to access the classic view - there is no option on the screen for it. I need to be able to use my contact distribution lists to schedule meetings. Where can I access the classic view again?