Direct Upgrade Procedure for Virtualized Cisco Unified Communications Manager Release 8.0(2)–9.0(1) to 9.1(x)
This document provides procedures for performing a direct upgrade to Cisco Unified Communications Manager (Unified Communications Manager) Release 9.1(x) from virtualized Releases 8.0(2) through 9.0(1).
About direct upgrades
Unified Communications Manager Releases 8.0(2) and higher support virtualization.
This document is applicable to Unified Communications Manager clusters with the following environment:
• Any of the following Unified Communications Manager Releases are installed: 8.0(2) through 9.0(1).
• Your current Unified Communications Manager release is running in a virtualized environment.
• No changes are required to the IP addresses or hostnames for the Unified Communications Manager upgrade. If you need to change IP addresses or hostnames, you must do so in a separate maintenance window, prior to the upgrade. For more information, see Changing the IP Address and Hostname for Cisco Unified Communications Manager, Release 9.1(1).
I have a Cisco 2911 router with the UC license running IOS c2900-universalk9-mz.SPA.157-3.M.bin abd a SM-ES2-24-P switch installed into it with 5 IP phones connected to the switch. Please note that this is a Service Module switch and not an external switc...
We have registered Webex Team (Windows )with CUCM.My Queries are following:1.Shall CUCM corporate directory work on Webex Teams,just like it works on Cisco Jabber.2.How can we retrieve voicemail on Webex Teams ,just like we do on Cisco Jabber.
Hi, It's nice that Expressway supports certification renewal with ACME / Let's encrypt. Sadly even the current 12.5.5 is still using ACMEv1. This is an old version and is being replaced with ACMEv2 since 2018.I've just had an issue where ACMEv1 didn'...
Hello, I'm running UCM 18.104.22.16800-16 and a subscriber node has stopped to authenticate users. LDAP authentication is configured but even local users fails authentication. There are no authentication attempts in UDS logs with enabled debug leve...
Hello, I am trying to configure Two-Stage dialing on a specific E1 number on a Cisco ISR 4331. All available official documentations does not include IOS XE configurations. I have configured the below:!voice service potsno direct-inward-dia...