cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Disable - Lockout Touch10 on SX80 CE9.3x

1206
Views
5
Helpful
1
Comments
Beginner

A system has a 2 way divisible room with two SX80s. When the rooms are combined, only one codec will be used. User does not want a notification message displayed on the secondary Touch10. 

Is there a method to lockout control of a Touch10 to prevent accidentally dialing on the unused system? Alternatively, would it be possible to pair the secondary panel to the primary codec so both Touch10s will operate one codec while combined, and then pair back to individual codecs when divided?

Thanks in advance!

1 Comment
VIP Advisor

There is no feature available in the configuration of the devices to do so.  If you had the second Touch10s connected to a PoE switch, then you could add some smarts to the room so that when it is used in a divided mode that the power is turned off to switch port of the Touch10 you want to disable. Note: you have also posted this in the "videos" section of the discussion forums instead of to the "discussions" section.  I'd suggest that you consider re-posting it in the right section.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards
This widget could not be displayed.