cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1953
Views
10
Helpful
0
Comments
Joshua Sandi
Level 1
Level 1

Requirements:

Cisco Jabber for Windows 9.1

Windows XP or 7 // Windows 8 not supported yet

CUCM 8.6

CUPS 8.6

Cisco 7965 SCCP

Configuration Steps:

Please check the following on the phone you're going to control:

On CUCM:

-Allow Control of Device from CTI (on the device and the line) and End User association with the device.

-Check that the Owner User ID is set to the Jabber user you want.

On Presence:

-Go to Application > Cisco Jabber:

- Check that the user is part of a CTI Gateway Profile

- Then go to CCMCIP Profiles ( if there's none you'll have to create it ) and see that there's the end user as well.

If you've checked everything above the recommendation will be to restart the CTI Manager service on the CUCM server that the  that should restablish connection

Note: Of course connectivity to the CUCM Server from the PC in question should be confirmed to use this feature, that's a basic thing you might want to check.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: