Here is how you collect LDAP info.docx

528

Views

Helpful

Comments

edited on: ‎03-12-2019 ‎09:51 AM

This doc shows the steps to collect the LDAP settings out of UPM 8.7 and later versions with the Prime interface.

Latest Contents

CME 12.0 8851 CP-BEKEM Will NOT Power On

Created by Michael Durham on 10-19-2019 11:56 AM

I have a Cisco 2911 router with the UC license running IOS c2900-universalk9-mz.SPA.157-3.M.bin abd a SM-ES2-24-P switch installed into it with 5 IP phones connected to the switch. Please note that this is a Service Module switch and not an external switc... view more

Webex Teams UC Calling

Created by faraz1234 on 10-19-2019 09:37 AM

We have registered Webex Team (Windows )with CUCM.My Queries are following:1.Shall CUCM corporate directory work on Webex Teams,just like it works on Cisco Jabber.2.How can we retrieve voicemail on Webex Teams ,just like we do on Cisco Jabber.

Expressway and support for ACMEv2

Created by Michael.Heimann on 10-19-2019 05:24 AM

Hi, It's nice that Expressway supports certification renewal with ACME / Let's encrypt. Sadly even the current 12.5.5 is still using ACMEv1. This is an old version and is being replaced with ACMEv2 since 2018.I've just had an issue where ACMEv1 didn'... view more

UDS authentication fails on subscriber

Created by Maxim Denisov on 10-19-2019 04:25 AM

Hello, I'm running UCM 11.5.1.16900-16 and a subscriber node has stopped to authenticate users. LDAP authentication is configured but even local users fails authentication. There are no authentication attempts in UDS logs with enabled debug leve... view more

Two-Stage Dialing On E1

Created by joseph.francis1 on 10-19-2019 02:49 AM

Hello, I am trying to configure Two-Stage dialing on a specific E1 number on a Cisco ISR 4331. All available official documentations does not include IOS XE configurations. I have configured the below:!voice service potsno direct-inward-dia... view more

CreatePlease to create content