In very large IP telephony installations, there might be pre-programmed limits on certain software. However, Cisco CallManager has the flexibility that few other IP Telephony solutions support.
On Cisco CallManager, there is no pre-programmed limit to the number of route patterns you can support on a Cisco CallManager server.
The actual limit is bound only by the available RAM and CPU resources on the server itself. When calculating the route patterns needed, each @ route pattern is actually a macro that expands to route 300 route patterns. The code has been tested with 1,000-plus patterns with satisfatory results.
To install Cisco CallManager, refer to your version of CallManager Release Notes to determine if there are limitations with your hardware.
#WebEx Calling# Datasheet lists the supported features, however no details what features are supported based on the deployment type:
Cisco WebEx Calling for Desk/ Conference PhonesCisco WebEx Calling for DesktopCisco WebEx Calling for MobileCisco WebEx Ca...
I have a cisco 8961 phone that I have hopefully set up correctly in CUCM 11.5. I have also downloaded and put in my tftp server the sip upgrade .sgn file. When I plug the phone in, I reset it to factory default and it gets an ip address from my windo...
I have a CUCM, CMS, Expressway C&E, TMS, TMSXE, One Button to Push, skype integration infrastructure.Skype will sometimes issue a conference ID that starts with '9'. This causes the system to treat the conference ID as a phone number (9 for outside li...
Collaboration Community, I am looking to setup a couple conference room phones but would like to not utilize more than one DN if possible, is it recommended or considered best practice to use a shared DN between conference phones or util...