. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
I have a Cisco 8961 running sip8961.9-4-2SR4-1 firmware. On my config file I have Bluetooth and the USB ports enabled. When I plug in a USB device it says that the port is disabled by the administrator. When I try to find Bluetooth in the setting I c...
I have a Cisco 2911 router with the UC license running IOS c2900-universalk9-mz.SPA.157-3.M.bin abd a SM-ES2-24-P switch installed into it with 5 IP phones connected to the switch. Please note that this is a Service Module switch and not an external switc...
We have registered Webex Team (Windows )with CUCM.My Queries are following:1.Shall CUCM corporate directory work on Webex Teams,just like it works on Cisco Jabber.2.How can we retrieve voicemail on Webex Teams ,just like we do on Cisco Jabber.
Hi, It's nice that Expressway supports certification renewal with ACME / Let's encrypt. Sadly even the current 12.5.5 is still using ACMEv1. This is an old version and is being replaced with ACMEv2 since 2018.I've just had an issue where ACMEv1 didn'...
Hello, I'm running UCM 188.8.131.5200-16 and a subscriber node has stopped to authenticate users. LDAP authentication is configured but even local users fails authentication. There are no authentication attempts in UDS logs with enabled debug leve...