. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
HelloI'm currently facing an issue with Cisco Jabber. I'm trying to move the history of Jabber chat conversations from one PC to another, but if I copy the .db file (over 11000 KB size) with history to the new PC, it resets back to default 10 KB size afte...
Hi guys, I've recently updated my jabber to 12.7.After a reset of the jabber software I've noticed that the plugins were gone and the contact pictures were not loaded, also the photo cache folder was empty.After some testing I saw that our jabber-con...
Hi, outbound call result 13 (Dialer stopped dialing customer due to lack of agents.) I've found this difficult to get a clear answer anywhere regards this outcome code and received the basic 'change your lines to agent ratio to avoid large numbers of thes...
Hi Folks, I'm in the process of upgrading and migrating a system from v10.0.1 to 12.5 using PCD. I am hitting a poblem with he same symptoms as bug CSCum18394 and error message of "ERROR An unknown error occurred while accessing the upgrad...
Hello Friends,We have an existing PCCE 11.6 setup running with two VVBs, one each on side A and one on B which are serving contact centre located in main office. Now we'd like to add a remote site (with contact centre abilities) and would like to add...