. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
Hello,I need somebody to help me how to create two reports in cuic 11.6 in the following fields Report 1RouterCallKeyDay (int ,not null)RouterCallKey (int , not null)CallTime (datetime)CLID (varchar (32) , null)QueueTime (int , null...
hi all i have problems with incoming calls from other ip phones to 8851 cisco ip phone with Newrock OM series ip pbx as the main pbx server!!outgoing calls from my 8851 ip phone are ok!!i tried reinstalling firmware but that wasn't helpful!i'm curren...
Hello, I am a final user who´s traying to find out some source of knowledge for some issues I am facing with my new Cisco 8845 3PCC connected to an Issabel PBX/Asterisk. I am coming from a “yeahlink” user experience, so It´s been quite a change in ab...
Hello, I have about 15 remote sites and 2 data centers. The data-centers both have CUBES that connect to the PSTN via provider SIP trunks. Each remote site also has an SRST. I have always assigned MTP via the MRG list for each site ...
Hi Peeps, I'm running a 12.0 cluster, and using solarwinds to monitor it. We constantly get "alerts" for phone registration rejected. I've argued with management to disable this useless alert, but they believe it to be valid. So I'm...