. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
I have Webex site with Hybrid calendar and call services enabled for Cloud registered Room Kit's, and when dialing a complete URI to any non webex.com or cisco.com domain the call fails. Troubleshooting it I saw the call routing into the Expressway'...
I've been doing some updates at several remote locations and somehow I broke Caller-id. We used some older 2811's as H.323 gateways as well as routers on a stick, during the process I updated the IOS from 12.4 to 15.1, increased the RAM, PVDM2, and added ...
Hi all, CUCM 11.5 I did my best to search Google, then signed up here searched and read a lot of discussions but could not find something solid that I could go on outside of creating new CSS, PT and then doing transformations and/or translations...
Hello All,I purchased the NFR 11.5 UC Packages a few months ago and I have voice lab now up/running. But the SIP Called Party Tracing doesn't display. I read that this is due to a beg. Could someone verify/assist. Is there a work0a-round. I think tha...
Dear All,I need assistance with the following issue.I set Call forwarding to my mobile number from my extension and call forwarding is working fine, but I see my extension's DID number on mobile which is causing inconvenience to identify in case of missed...