. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
Hello,We have Cisco 8811 (SIP) phones registered in Cisco CUME on a Cisco 4431 router. Is there a way to disable the speakerphone and call logs in the CME router for the 8811 phones? We're digging to find the commands. Haven't found them...
hi all we have user sitting in reception and request to have access call forwarding for all the phones in the office. so when user not in office they can just change it to a number. (3000phones) can you please give me some options or exisiting p...
Hi Folks, I have implemented MRA via expressway and apple push notification service for Cisco jabber. It works well however I have few queries: 1) In jabber client on iPhone I can see internal CUCM and Unity connection IP address under phone ser...
New to UCCX scripting, but I wrote and entire medical eligibility UCCX IVR app and I'm stuck on this one thing only.What do you use in the script to execute this webcall. "http://192.168.5.5/logEnter.php?LOG_ID=2222"This is a confirmation number add to th...