. If someone calls you on your deskphone and SNR is configured like your mobile phone is associated with your deskphone, your mobile phone will also be connected after configurable number of seconds. So when you are moving somewhere from your desk and, your call will never me missed
Now let’s talk about it’s configuration, it’s pretty easier to configure, follow me:
1. Create an end user and associate his deskphone at his profile:
2. Configure Remote Destination Profile (RDP):
Go in Device->Device Settings->remote destination Profile
Things to keep in Mind!
1)Make sure your remote destination number ie your Mobile number matches a Route pattern going to your Gateway 2)Make sure the Re-routing CSS has the access to the Route pattern to successfully route the call to your mobile number.
3)Associate the Line number to your Desk phone extension (very IMP)
3. Configure Remote Destination:
Go to Device->Remote Destination
Things to keep in mind
Make sure you check Mobile phone and enable Mobile connect.
Associate it with the Remote destination Profile.
Now let’s have a try calling your deskphone, your mobile will also be connected after configured seconds (4 seconds by default), if you answer your call from the mobile your deskphone can sense it! wohoo!! your deskphone line will lid red as long as you are talking over mobile. okey, now think you have reached near to your desk and now you want to keep talking using your deskphone, so hangup the call from the mobile it will get hold automatically and now resume it from your deskphone .
We were in the process of upgrading PCCE from 11.6 to 12.0 and what we found during CUIC upgrade that it fails and when we checked in the replication , it says replication_not_setup on both cuic publisher and subscriber nodes.Please advice if anyone has o...
Hi thereI wrote a Webservice for my customer and a simple Webinterface. I added now a custom tab for it and it works fine internaly (and VPN). But over MRA it is not working: Jabber:Page failed to load.URL: http://xxx.contoso.int/index.htmlError...
When agents make manual outbound calls , the skill group is displayed as CUCM_PG_1.Cisco_Voice.defa in Livedata.Is there a way to change / mask the skill group to some other name so that supervisors can view in CUIC as manual outbound.
i receive the below message every days ,what is the meaning : Microphone Overloaded Error::State=unacknowledged;Component=........ ................ .......... ..........;Description=Microphone(s) overloaded. More Information: OverloadedMicrophone=2