This document covers the procedure on how to configure the custom alerts and setup email notification in Real-Time Monitoring Tool (RTMT)
Real-Time Monitoring Tool is the ability for the tool to send e-mails when an alert is triggered. In this example we will see how to set up a simple alert, which sends an e-mail when less than 5 MTP resources are available to the helpdesk recipients.
Perform the following procedure to configure e-mail information for alert notification. As a prerequisite for email alerts make sure you configure the email server.
1. Log in RTMT Tool
2. Add the performance counter you want to create an alert in the monitoring page
Choose System > Performance > Open Performance
3. Add the Resource Available counter from Cisco MTP Device from the Tree
4. Specify an Instance/ Device to monitor - Double-click it to monitor the counter
5. Add the counter and then configure the alerts by right-clicking the counter and Selecting Set Alert/Properties
6. Alert Properties: General window will open
Check the "Enable Alert" checkbox
Specify, Severity : Warning
Specify, Description for the alert as "Available MTP resources" and
Specify, Recommended action
7. Click Next
8. Next comes the Threshold & Duration Window - Specify the threshold Value
Specify Threshold: Trigger alert when following condition is met as : Under 5 (as per requirement)
Specify, Value Calculated As : Absolute (as per requirement)
Duration : Trigger alert only when value constantly below or over threshold for 60 seconds
9. Click Next
10. Frequency & Schedule window will appear
11. Select the Frequency and Schedule
Frequency : Trigger alert on every poll
Schedule : Trigger Alert everyday (Scheduled Monitoring between) - Mention the Start Time and End Time
12. Click Next
13. Finally Email Notification window will appear
Check "Enable email" checkbox
Mention the "User-defined email text" to be mailed while triggering the alert
14. Select the "Trigger Alert Action" from the drop-down
-- This specify the list of users who shall receive an alert e-mail.
hello everyone!!!! Hope you are well. Im trying to understand these reason codes, but in the Database Schema does not say anything about this? 028064407639332 Do you know something about this? Thanks in advanced.
Dear Folks, I bought a Cisco 8945 phone.The phone is connected to the home broadband network. It is successfully registered with the local VoIP carrier.However it cannot receive incoming calls or make outgoing calls. [CP-8945] 00:00:54:31.078 - ...
Is there a difference in recording calls and mra. We have mra and recording seems to be working for jabber on a laptop vai expressway. The wierd part is that we don't understand why jabber on a mobile with mra via expressway doesn't work but via lap...
When I schedule larger WebEx Events meetings for our system we have a password for attendees and also one for the panelists which is normal or at least seems normal with the invites it creates. When an attendee tries to join from any of our Cisco video en...
Hi We are expanding our outbound dialer from 2x locations to 5 in total for different units. My question is how do we monitor the dialler with regards to congestion due to the units and different dialler compaigns When Would we, in the fut...