Cisco Community
English
Register
Community will be in Read-only Mode from April 11 at 11:00 PM PT to Monday April 12 at 9:00 PM PT - READ DETAILS HERE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays

How to configure the VIC-4FXS/DID card on a Cisco 1751 and 1760 router

3011
Views
0
Helpful
0
Comments
TCC_2
Advocate
‎06-22-2009 03:38 PM
edited on: ‎03-12-2019 ‎08:31 AM

Resolution

The Cisco 1751 router can support three 4-port Foreign Exchange Station (FXS)/Direct Inward Dialing (DID)   voice interface cards (VICs) and up to a maximum  of four DID ports.

The Cisco 1760 router can support four 4-port FXS/DID VICs and  up to a maximum of eight DID ports.

The 4-port FXS/DID VIC provides both FXS and DID functionality on a single  VIC. You can select either FXS or DID mode on a port-by-port basis. The default  mode is FXS.

Refer to Configuring VIC-4FXS/DID and Understanding Foreign Exchange Station (FXS) Voice Interface Cards for more information.

0 Helpful
Latest Contents
cant remove ccx warm standby license usage?
Created by baselzind on 04-11-2021 03:16 AM
0
0
0
0
please I have ccx 12.5 where I installed a subscriber by mistake without knowing that I don't have a license for it. Now im getting license compliance issue for "CCX permium warm standby 12.5" even after I removed the subscriber and restarted the publishe... view more
Dial Peer Preferance - POTS & VOIP
Created by Ahmed Abdulla Mohammed Sallam on 04-11-2021 01:11 AM
7
0
7
0
Good Morning ColleaguesI hope you are doing good and safe. I have configured 2 dial-peers , One for VOIP (SIP trunk to third IP PBX) and another POTS for outbound/incoming calls to & from PSTN. The extensions at the third party IP PBX are 1x... view more
UC-One SaaS pre integrated Apps - Salesforce integration
Created by parlos on 04-10-2021 06:55 PM
0
5
0
5
Hello, we are service provider and have migrated to UC-One SaaS platform. The datasheet talks about pre-integrated apps and for our case I only see a plugin to integrate with outlook, no clue where to find the options to enable the integration. We are par... view more
Consider If Formula - Agent ID Associated with a Skill Group
Created by abhilash2001 on 04-10-2021 10:52 AM
1
5
1
5
Hi Everyone:  I am trying to figure out a Consider If Formula for an Agent ID/Peripheral Number associated with a Skill Group. Basically, I am trying to queue to an agent, and if my agent is not available, I want to queue to a skill group this a... view more
Jabber - Photo in My profile section
Created by Alberto Sanz on 04-10-2021 07:48 AM
0
0
0
0
Hello,we have deployed on-premise Cisco Jabber 12.9 and we get the contact's picture from AD successfully but the user's picture is not showed in "My profile and settings"we have tested Cisco Jabber 14.0 too.our jabber-default.xml file is:<?xml version... view more
Content for Community-Ad

Spotlight Awards 2021