Caller ID is an analog service by which a telephone central office (CO) switch sends digital information about incoming calls. The Caller ID name delivery feature for analog Foreign Exchange Station (FXS) ports was first introduced in Cisco IOS Software Release 12.1(2)XH. It is available on all subsequent Cisco IOS software releases. This feature is available and configurable on a per-port basis to phones connected to analog FXS voice ports. This feature is also available on analog Foreign Exchange Office (FXO).
The [no] caller-id enable command enables or disables the transmission of Caller ID on an FXS port, and enables or disables reception of Caller ID on an FXO port.
Issue the [no] caller-id enable command to enable the Caller ID name for inbound PSTN calls on the FXO port.
You must configure the alerting method when the Caller ID standard, specified by locale through the cptone command, is not Bellcore/Telcordia. If you do not configure the alerting method, the default caller-id alerting ring 1 command is applied. The command that you enter is determined by the Bellcore/Telcordia or ETSI standard that your service provider uses for Caller ID.
Note: This command works only if the gateway is configured as H.323 with the Cisco CallManager. If a Media Gateway Control Protocol (MGCP) configuration is used, Caller ID is not supported on the FXO port.
We were in the process of upgrading PCCE from 11.6 to 12.0 and what we found during CUIC upgrade that it fails and when we checked in the replication , it says replication_not_setup on both cuic publisher and subscriber nodes.Please advice if anyone has o...
Hi thereI wrote a Webservice for my customer and a simple Webinterface. I added now a custom tab for it and it works fine internaly (and VPN). But over MRA it is not working: Jabber:Page failed to load.URL: http://xxx.contoso.int/index.htmlError...
When agents make manual outbound calls , the skill group is displayed as CUCM_PG_1.Cisco_Voice.defa in Livedata.Is there a way to change / mask the skill group to some other name so that supervisors can view in CUIC as manual outbound.
i receive the below message every days ,what is the meaning : Microphone Overloaded Error::State=unacknowledged;Component=........ ................ .......... ..........;Description=Microphone(s) overloaded. More Information: OverloadedMicrophone=2