When the current size of the queue exceeds the maximum size limit set for the queue, the element can no longer process traffic. When the queue exceeds the maximum size, the queue starts to drop elements either from the front or back, on the basis of the discard policy of the queue.
Use Simple Network Management Protocol (SNMP) traps to notify the SNMP console about certain events. Enable the "sipTrapUAQueueMaxSizeExceeded" trap to send a notification when the current size of the queue exceeds the maximum size limit set for the queue.
Perform these steps to configure SNMP traps:
Verify whether the "sipTrapUAQueueMaxSizeExceeded" trap exists under the Command Line Interface (CLI) context SNMP. This is the command:
Hi everyone, Users on my company suddenly getting a popup certificate when they trying to login the jabber.akamaicdn.webex.com - this is the certificate.Anyone know something about it? Thanks for you help.
cisco IP phone cp-7811 not getting DHCP ip address in one Catalyst 9200 switch the same phone can get IP with other 9200 switchesI have been checked everything correctly configured!interface GigabitEthernet1/0/3switchport access vlan 998switchport mode ac...
I called Safeway in the U.S. today, and their initial hold music was familiar, but not Opus 1. Then when an agent put me on hold again, it was Opus 1. So it seemed to be Cisco telephony, but a different track. Is there a track list available somewhere? Th...
hello my device：room kit plus is registered with Cisco Cloud Server However, my device will often automatically disconnect during the meeting. The call history and disconnection reasons are as follows. Does anyone know how to solve this pr...