How to verify Jabber for Andriod 9.X COP file has been installed properly?
As you aware, Jabber for Android 9.x required COP file cmterm-android_9.0.1v24.cop.sgn to be installed on all CUCM servers. How to check whether the COP file has been installed properly on CUCM Servers?
1. Run the below command from CUCM ssh console to see if the COP file is appearing.
admin:show version active
Active Master Version: 188.8.131.5200-2
Active Version Installed Software Options:
After installing the COP file, all the servers must be rebooted. Sometimes customer could just installed the COP but didn't reboot the server. You need to reboot the server after the installing the COP file. Just restarting the TFTP service is not enough.
2. Verify the COP file installation on CUCM
Step 1 Sign in to the Unified CM Administration portal.
Step 2 Choose Device > Phone.
Step 3 Click Add New.
Step 4 From the Phone Type drop-down list, choose Cisco Dual Mode for Android.
Step 5 Click Next.
Step 6 Scroll down to the Product Specific Configuration Layout section, and verify that you can see the Enable SIP Digest Authentication drop-down list.
If you can see the Enable SIP Digest Authentication drop-down list, the COP file is already installed on your system.
Hi all, I need your help please .I have a IP Phone Gigaset C530 registered on cucm 12.5 , the problem that i have i can't see the number of caller extern when the call transferred via another ip phone . Could you help me please ? ...
Hello, Recently I have noticed that our call manager exported cdr file size increasing insanely, now 7 days creats exported file of 800 MB size.My question is, how can I decrease the resulted file size as possible?Knowing that months bef...
Hi All, We are on CUCM 12.5 and CCX 12.5, from time too time we get the swap disk partition going over 90% and gets stuck there.Currently we resolve the issue by rebooting the affected server.I have been reading up since the customer started asking q...
Hello cisco community, in the book CLCOR 350-801 I read the following statement on pages 202 and 203: The phone will then use these VLANs (data and voice switchport configurations) to tag all communication originating from the phone with the voi...
CME 12.0 - 9971 registered phone, phone A (sip9971) calls phone B (sip7975)Phone B (sip7975) has a conf softkey and can initiate a adhoc conference with phone C (sip 9971) all is well. If you try to replicate this the other way around there is no con...