In CCM 5.x, when the Australian Dial Plan is used and the Media Gateway Control Protocol (MGCP)IOS gateway configuration is used to change the ISDN Number Plan Type to National, non-National calls result in a call setup failure.
These calls include those to mobile phone numbers and numbers without national area code prefixes, such as local calls. Emergency number (000) and 10-digit numbers with an area code national prefix work and are processed through to the Public Switched Network (PSTN). When the Numbering Plan Info Service parameter is set to "2", there is no effect. The Number Plan Type in the gateway must be set to "unknown" in order for the call to proceed.
The implementation is as designed at this time, wherein calls fail if the number dialed is not matched to the plan setting.
In order to see the Gateway Configuration set to "National", change the Australian International Dial Plan (IDP) such that all numbers are seen as type "U" for Unknown. In this way, all dialed numbers work.
The dial plan is developed, updated and owned locally for each country. Any changes required are submitted to the country owner in order to qualify, and then a signed .cop file is produced by the Cisco engineering team. That way, an end-customer can upload it with the awareness and support of Cisco Systems.
In order to modify and customize a specific country IDP and receive support, a request must be submitted to the dial plan owner to qualify, either through their Cisco account team or in the form of a TAC service request. The resulting engineering process can provide an updated dial plan file for upload to the Cisco Unified CallManager cluster.
Hello, I have UCCX Standard 12.5. I do not have any premium licenses. I am trying to find information on how to integrate some sort of "chat with customers" feature on our public website. Based on my research, this feature was avail...
Good Day, we bought our first Cisco ATA 191 but cannot configure it.The device have an ip from the DHCP-Server.After connecting to the web http://x.x.x.x we can login with admin/admin.There is no option to configure anything. We have the tabs "Voice"...
Came across this the other day, a CUCM installation using UCL licensing showing licence violation. The cause was two phones with the same owner ID, as a result it was looking for at least an Enhanced Plus licence. I am fairly sure I've seen it...
Hi everybody, I have the following scenario: IP Phones (7821) - CME --- (SIP Trunk)---- PSTN. The outgoing calls are well, no problems with that. But in the incoming calls in first case (With rel100 enabled) doesnt establish calls. Ok,...
Hey,I installed CWMS 4, it supposed to be with HA and IRP.I manage successfully to connect the Main IRP to the main system,But when I try to add HA from the second system(when I choose "use this system for HA", and check the "use IRP", Manual deployment)T...