In Cisco CallManager 4.x connected through E1 to 3845 router, which is used as a gateway, when an IP...
In Cisco CallManager 4.x connected through E1 to 3845 router, which is used as a gateway, when an IP Phone calls up a phone behind the Nortel PBX, the IP Phone gets silence for a brief period and then a busy tone
In this scenario, this can possible be an intermittent problem, that when a call generated from an IP phone to Nortel phone does not give any tone such as a Ring Back or Engage. The IP Phone receives just silence for some time and then a fast busy.
This can possible be a visio for this kind of network:
IP Phone--> CallManager----> E1 R2 Gateway(3800 Series)--> Nortel PBX--> Phone
It has been observed that when Line signaling is defined as R2-Digital or R2-Pulse, the requirement for R2-Analog results in the same behavior. In order to resolve this issue, change the Line signaling to R2-Analog.
Refer to these documents for more information about E1 R2 Signaling:
For the security Reason we want to use 7443 for Secure Bosh connection for Customer Collaboration Platform. Is it ok to use 7443 instead of 7071 from Cisco Customer collaboration to UCCX server ? we are trying to do this for the first time in our or...
Is there a way to turn off the multiline function or have the ability to prevent the call notification popup for certain lines in Jabber 12.9? We recently upgraded from Jabber 11.9 to 12.9. A couple of our executive assistants who monitor 8-10...
Recently upgraded to version 22.214.171.12401-348, Two servers in the cluster, publisher and subscriber.100 agent model - so 2 CPU / 10gb RAM / 1X 146 DiskTypical Agent usage is .. 10 agents but occasionally we have 30-40 agents in use.We have 120 ...
According to the 14 Upgrade and Migration guide, PCD is recommended when upgrading CUCM, CUPS and CUCX together. Is there a specific reason for that? I'm not seeing a reason anywhere and I prefer to manually upgrade through Web/CLI.