cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1132
Views
0
Helpful
0
Comments
TCC_2
Level 10
Level 10

Resolution

To overcome this issue, perform these steps on the router:

  1. Verify that the proper Digital Signal Processor (DSP) resources are available on the router. Refer to Users cannot configure the PRI-group and "% No DSP resources available to configure pri-group on controller E1 or the No DSP resources available to configure pri-group on controller T1" error message is received. You must have have free DSPs to support the current or new configurations on the router.    
  2. The DSP errors also occur because of incompatible Cisco IOS  Software images on the router. To select your platform and the latest compatible Cisco IOS Software image, refer to. Cisco IOS Upgrade Planner
  3. Reload or power cycle the router.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: