Incoming PRI calls are disconnected after a two to three second connection by Cisco CallManager. debug isdn q931 shows the "Message not compatible with call state" error message as the disconnect reason
The issue is addressed in Cisco bug ID CSCdy26520.
This issue is observed when connected to certain ISDN networks. When Cisco CallManager is the user side of the Primary Rate Interface (PRI), it sends a Progress Indicator IE in the alerting message sent, which is invalid in some PRI protocols.
In the case where Cisco CallManager immediately connects, the call after this, such as when it forwards to voicemail or answers with an auto attendant, the ISDN network complaint about the Progress Indicator comes after you already send the Connect message, which causes a protocol violation, and Cisco CallManager disconnects the call. This only happens with a Media Gateway Control Protocol (MGCP) controlled PRI gateway.
Disable Alerting Progress Indicator This parameter determines whether the alerting progress indicator to Inband Information is reported to digital PRI gateways. Valid values specify True (disable the alerting progress indicator) or False (send the alerting progress indicator).
This is a required field. Default: false.
In certain configurations, in order to receive ring back, you must set this field to False in order to force media cut-through.
Complete these steps in order to resolve this issue:
Change the service parameter Disable Alerting Progress Indicator to True.
Use the Cisco IOS Software Release 12.1.3*T*, where the issue does not exist.
In case this issue is not resolved, use the TAC Service Request Tool in order to open a case with the Cisco Technical Support.
Hi Friends,We have PCCE 11.6 (1) environment running and recently we have started using SIP Outbound dialer. The dialer works fine in Preview_Blended mode with changing OutboubdPercent variable based on the call volumes (inbound and outbound)...
Hi, Guys. We have something problem with Enterprise Chat & Emai, after we start chat usinng Enterprise Chat and Email we have error "System cannot assign an Agent to the request". Has anyone ever had a problem like this? The infrastruct...
We have a user that has an issue with when she is going into webex teams on the local machine, the font size is jumping from regular size to large and stays large for the time she is in the application.We tested this on our citrix environment and the font...
Forwarded calls shows "Forwarded" instead of the display name for newly configured phones after upgrading the cucm from 10.5 to 11.5. CUMC version 11.5Call type internalPhone type 7945 Its working fine for existing phones with the same version o...