This issue occurs with the Cisco 7960 IP phone when a 7914 expansion module is used.
In this setup, there is one line on the phone and one line on the expansion module. You can press the Speaker button to answer calls that come in on the line configured on the phone. However, when calls come in on the expansion module line, you cannot pick up the call after you press the Speaker button.
In order to answer the call, the user must press the Answer softkey.
Also when a sidecar line is in active call, you cannot press the Speaker button to hang up the call. Use the handset and EndCall softkey in order to end the call.
In both the cases, the phone display prompt changes from speaker to handset. However, the call is never picked up or ended. The root cause is that when you send the StationOffHookMessage, the phone sends the line button number instead of the line instance.
This issue is documented in Cisco bug ID CSCsa69644.
This issue is resolved in the phone load version 7.2(1).
I am experiencing a trouble when I set a campaign up and I try to enable it. Indeed, it simply does not start any call.tl;dr: after the campaign definition, I enable it. Pending contacts number goes immediately to 0 but any call is performed.Context detai...
I am looking to change our "Dial Out" number from a "9" to a "7". To avoid ruining our current settings, I copied the existing call patterns and changed them to start with "7"; however, it seems as though this new pattern is not applying. Do I need t...
Hello I have a CUCM 12 and I already configured Intercom Line for 2 Phones and It works well. Now I wanted to configure another phone with one of the Intercom line configured and I couldn't do it because I think intercom line is just for 1 phone...
Hello again,We are tying to figure out how to create a new user in finesse. We don't know how to navigate through out the software. Apparently we need step by step instructions. We are unable to follow the Finesse AG 11.5. I know this a sad case. SMH!&nbs...