Please find below a tool to simplify the extraction of SIP Messages of a CUCM Trace. This could be usefull for debugging and troubleshooting purposes. This tool is developed by myself and provided 'AS-IS' with best effort support. Notice this is not funded/supported actively by TAC or any BU. This was initially developed at TAC to expedite trace analysis and resolution however I have decided to extend the audience. There are multiple tools that might follow up this initial release.
Parse SDI Traces to extract all messages related to a Call-ID, or CUCM CI.
Generate Summary Graph of SIP Interactions.
Indicate Direction of Message, Time and IP Address involved.
Fast Lookup speed thorugh regular expressions.
GUI and Simple to use.
NSI based installer, without admin rights required.
Steps to Use:
Install using the intuitive installer found at the download section.
Open the Application.
From Menu File -> Open Folder, select the folder with the uncompressed traces. The tool will lookup recursively (all folders down) to find files.
Input the SIP Call-ID, or CI for the call you want to extract. You have to obtain this before (we have another tool to this comming soon).
Click find and wait while files are been parsed.
You should get two tab with the summary of the call and the complete message.
We have a DX80 that has the error message "Microphone not detected" displayed at the top of the screen.Remote System Diagnostics check does not show any issues.Configuration shows "Input Microphone Mode: FocusedWide" and "Microphones Mute Enabled: InCallO...
Hello all!I'm trying to figure out if this is advisable. I have come across a situation where a mixed-mode 12.5.1 SU2 CUCM cluster has had multiple trust certificates expire either at the same time or within a short span of time. The expired c...
We recently migrated from UCCX11.6 to UCCX12.5, one of the function that allow contact centre team lead reset prompt to blank was broken. I could not figure out what went wrong.The call flow is like belowcall application |enter ...
Hello all, I need your support, my configuration made for sip tunk on the CME is peer to peer. also the most of CDR created with originate and answer two rows of record. But accutally some of CDR that sent to billing server by FTP without orign...
I have a Cisco 7821 3PCC registered via SIP with an ITSP that is unable to make external calls but has no problems receiving inbound calls.I factory reset it and put in all the SIP settings I needed to put in to register it. Opened up my home router with ...