I'm in Australia and am trying to get an SPA112 working on an LG LDK-130 PABX with analogue trunks.
The 2 ports of the SPA 112 however have echo in incoming and outgoing speech when using a simple analogue handset. Is there any amplifier on the analogue side of the SPA that can be adjusted to lover the audio levels on the phone ports?
recently i have made changes to jabber-config.xml for a customer who requested to hide/change the information displayed on the profile of the contacts.
to do so i changed the values for some of the directory variables for example:
I have a VG350 configured as MGCP from CUCM ver 105. I have a number of analog phones connected as loop-start. The phones work ok; however, some of the users want the ability to have services such as hold and transfer. Will I need to reconfigure the V...
we have one installation of Expressway-C and E where the E has one single NIC with NAT enabled.
The MRA Zone from the C to the E is connected to the Public NAT IP (NAT reflection) and the Zone is working / established.
But the Zon...
We bought a BE6K system (CUCM+CUC) to replace the existing PBX. But there is no ISR router in the purchased list.
The existing PBX has a SIP trunk to the carrier.
I understand In Cisco preferred network architecture, ISR is required.&...
we are trying to install a VTC environment with following products CUCM (11.5) + Expressway C/E (8.11) + ISDN Gateway 3241 (2.2). At the moment the ISDN-GW is registrated at the Expressway-E as H.323 GW.
For this connection we have ...