Theisdn bind-l3 ccm-manager command backhauls (tunnels) ISDN Layer 3 (L3) and higher layers to the Cisco CallManager. PRI/Q.931 signaling backhauls signals (Q.931 and higher) for processing from a PRI trunk that physically connects a Media Gateway Control Protocol (MGCP) gateway to a MGCP call agent. The ISDN lower layer information (Q.921 and lower) terminates and is processed on the gateway. The L3 information (Q.931 and higher) is transported over TCP to the Cisco CallManager (MGCP call agent).
This problem is discussed in Cisco bug ID CSCed15644.
To resolve this issue, perform one or more of these steps:
Reload the gateway.
Manually add the isdn bind-l3 ccm-manager command to the gateway configuration.
If the ccm-manager config command is configured, remove it from the configuration and set the missing command (isdn bind-l3 ccm-manager) under the serial interface. Then, save this configuration to the Nonvolatile RAM (NVRAM), and reload.
Hello.I have Cisco 7960G IP Phone that registered in CUCM 10.5.2 .I define some of directory numbers with urgent priority eg. 2248. when someone tries to dial a number like 22485631 in phones except 7960, if he first types the numbers in on-hook state and...
I have a VWIC2-2MFT-T1/E1 card in a 3825 router. After a power outage it is no longer connecting. When the router is powered back up both ports on the T1 card have the Alarm light on even without any cable plugged in. Is this a configura...
Hi All What are the explanation for SIP servers in Cisco terminology? If the all the server types are integrated on CUCM, what are feature or settings it would be? Proxy Server:Redirect Server: Registrar:Location Server:I have some understa...
We have just implemented UCCX 12.0 for staging and testing.Write after the installation we could not access the <IP Address>/appadmin page. followed the installation guide and it does not show any steps required after the fresh install. a...