These are among the possible causes for this problem:
The Cisco Emergency Responder server may not be running.
The phone tracking process may be running.
There may be a Lightweight Directory Access Protocol (LDAP) failure.
You cannot delete a switch when a phone tracking process is in progress. Retry the deletion after the process has ended. If this is not the problem, the Cisco Emergency Responder server might not be running. Check the control center and restart the server. Refer to Troubleshooting Phones in Cisco Emergency Responder.
If the problem persists, there might have been an LDAP failure the last time you tried to update the switch configuration information in Cisco Emergency Responder. Try updating the switch information again (for example, by changing the notes). If the update is successful, you should be able to delete the switch from the Cisco Emergency Responder configuration.
For more details on resolving Cisco Emergency Responder issues, refer to these documents:
Hello Everyone, Currently I am using a cisco call manager that is used only for internal calls. We are looking for ways to lock down who can call who within our building and I was wondering if I could use FAC to do this function. Currently I hav...
hi, i would like to add an trigger via UCCX configuration API with postman for testing purposes. Application and CallControlGroup are valid entries. The trigger can configured manually (is deleted after tested :-))This is the URL: https://<server&...
Is there any special config needed to make calls out from CISCO Jabber when in extend and connect mode. I can receive calls fine and was able to answer them on mobile. But when calling out, there is no call being made to remote destination nor the called ...
How can I, or why can't I access a Webex My Contacts Distribution List when inviting attendees to a Webex Meeting? The only option I have is to copy and paste email addresses. I cannot access My Contacts at all from Webex Meetings. Webex Events lets ...
Hi,I have video devices like (spark room kit, kit plus, SX80, kit mini etc.), these devices are registered to CUCM ver 11.5.Requirement:There is an external H323 video conference call, and I want to dial a public IP address from these devices over express...