This document discusses how to Troubleshoot No-way audio/ dead Air Issue for the PSTN Outbound and Inbound Calls.
Outbound and inbound calls are not working - no-way audio. The PSTN Outbound and Inbound Calls are going through and getting connected fine but after that there is nothing heard, No-way audio/dead air issue for the PSTN calls outbound.
Mobile phone->PSTN -T1 PRI--> MGCP Gateway -->CUCM -- IP Phone
MGCP Gateway IOS version 12.1
1) The CUCM traces revealed that the call was connected fine and there was no issue found in the sdi/sdl traces.
CUCM only plays role in the call setup /tear-down of connection but not during conversation.
The Inbound and outbound calls have symptoms of dead air.
CUCM traces reveal that the call connects all fine and there seems to be loss of audio packets.
While testing the call customer didn't notice any change in TX count. It was showing zero while RX count was increasing gradually.
Installed the Wireshark tool.
2) The Gateway isdn debugs below also didn't reveal the root cause. MGCP Gateway Debugs
MGCP Gateway Debug for Troubleshooting
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Facility i = 0x9F8B0100A10F02014A06072A8648CE1500040A0100
We have configured the Call forwarding function in our office. Is there any capability to show the customer's original phone number on our agent's mobile screen? As an example: Let's assume that the customer with the number 479-555-15-55 dials t...
Looking to configure a phone book for cloud registered devices. The endpoints were on-prem and had been using the TMS Phone book, however once registered in the cloud. There doesnt seem to be any way of adding contacts or custom phone book etc to the endp...
Hello, I am working on setting up SSO for CUCM 12.5 SU2. The IDP system is ADFS4.0 on Windows server 2019. We are using certificates signed by our CA. I have found documentation to integrate with ADFS2.0 and 3.0. Has anyone ha...
Good evening, We are facing an issue regarding retrieving contacts from the Directory in the deskphones. A CUCM Pub server is used as the Directory server for other 3 clusters. This server has been configured both in the enterprise parameters a...
Hi Everyone, I have an issue with Inbound calls from ITSP that has been connected to my cisco VGW through SIP trunk, I got the following disconnect cause: Disconnect Cause (CC) : 57Disconnect Cause (SIP) : 403appreciate you support to figure out...