As you may know, UCCX 8.0 is the latest version of the Cisco Contact Center Express software out on the market, and in the past month we have seen a lot of our customer to upgrade their old systems to this new version, not only because some of the older versions will be out of support early next year but also because of the great new features available on this new version.
One of the big changes in the 8.x version is the licensing model, as it changed from a non node locked license to a node locked license schema. In the old versions of UCCX the license was not dependant on the hardware of software configuration, so basically you were able to use any license on any server without any issue. But in this new version the license gets associated to something we call now 'License MAC', which is a 12 digit HEX value created by hashing a great deal of parameters that you configure on the server, including:Time zone, NTP Server 1 (or ‘none’), NIC speed (or ‘auto’),
Hostname, IP Address, IP Mask, Gateway Address, Primary DNS, SMTP Server (or ‘none’), Certificate Information (Organization, Unit, Location, State, Country), etc. If there’s a change on any of these parameters, the License MAC also changes and you will need to request a re-host license to the Cisco licensing team in no more than 30 days.
There are two different ways to get the 'License MAC’.
First, there is the “Cisco Unified Communications Answer File Generator” to get the information prior the installation so you can request the license to Cisco as soon as you decide to upgrade your system.
To access the “Cisco Unified Communications Answer File Generator”, go to
After you enter all the information requested by the web page, you just click the "Generate Answer Files & License MAC" button and new window will popup with the License MAC that you should use to request the permanent license.
Also after you install the server you can use the 'show status' command from the CLI or from OS Administration to get this information as well.
If you would like to get a feel of the capabilities offered by this new version of UCCX, you can use one of 4 different demo packages (IP IVR, STD, ENH and PRE) that come with the Unified CCX 8.0(1) installation DVD which contains 4 demo licenses. Demo license works for 30 days.
Hello Experts, 1) Would it be possible to adjust the active listening settings so that we can remain connected to the agent's line at the end of the conversation? It was possible with CAD.2) Would it be possible to listen to calls from a specific que...
Hi!Very new to this forum, but just wanted to ask if anyone else have encountered similar issues with this device and what their end result/solution was. In April+- we had 2-4 phones that suddenly died in the same location "ish", mix between 7960 and...
hello every one I just had fresh install for CUC and I can only log in to CUC OS Administration , on the other pages it till me "Log on failed - Invalid User ID or Password" I can access the CLI , I tried to reset the password ...
Hi,I'm pulling my air out since last week. Here's my problem. It has been over a year that I setup a phone system, and everything was working fine. Then I changed my setup last week. My old setup was basically like this:cucme (2811) ==> ISP Router...