cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

Unable to configure the available DSP to be used for hardware conferencing in Cisco CallManager on an IOS voice gateway with DSP resources already allocated

1846
Views
0
Helpful
0
Comments

Core Issue

This is Working As Designed (WAD).

Resolution

Conferencing needs a dedicated Digital Signal Processor (DSP) resource. If a DSP is assigned for a conferencing session, then it cannot be used for transcoding or voice call initiations, or terminations. However, transcoding and voice calls can share the resource of a single DSP.

Note: Conferencing needs a dedicated DSP, but not a dedicated packet-voice DSP module (PVDM)2. For example, PVDM2-64 contains four DSPs. If one DSP is used for conferencing, the other three DSPs can still be used for other purposes.

Once the DSPs are assigned to the PRI, they cannot be used for other purposes. However, you can use the remaining DSPs.

Refer to these documents for more information:


CreatePlease to create content
Content for Community-Ad
FusionCharts will render here