If you have upgraded from Cisco Unified Communications Manager 5.x to 7.1(3), you will be unable to delete Bulk Administration phone templates that were created with the Cisco IP Manager Assistant. Instead, you will receive the following error:
"Update failed.  Security Profile is required for this device"
To diagnose the problem, run the following command from the command line :-
run sql select pkid, name, tkmodel, tkdeviceprotocol, fksecurityprofile from device where my_lower(name) in ('<template1 name>','<template2 name>','< template3 name>')
To fix the problem, run the following commands from the command line:-
run sql select pkid, name from securityprofile from device where tkmodel = <model from above> and tkdeviceprotocol = <protocol from above>
run sql update device set fksecurityprofile = '<security profile pkid from above>' where my_lower(name) in ('<template1 name>','<template2name>', '< template3 name>')
Adding or Updating SIP Dial Rules Causes Cisco TFTP Service to Rebuild All Phone Configuration Files
When you add or update a SIP dial rule in Cisco Unified Communications Manager Administration, be aware that the Cisco TFTP service rebuilds all phone configuration files, which may cause CPU to spike on the server where the Cisco TFTP service runs, especially if you have a large system with many phones. To ensure that CPU does not spike, add or update the SIP dial rule during a maintenance window or temporarily stop the Cisco TFTP service in Cisco Unified Serviceability before you make the configuration change. If you stop the Cisco TFTP service, remember to restart the service in Cisco Unified Serviceability after you add or update the SIP dial rule
I am attempting to write some scripts in C# that will take advantage of the UCCE 11.6 Rest API. In particular, I am looking to do bulk agent creation. I am able to successfully connect to the remote server where UCCE lives, but when I try to se...
We are installing a voice gateway (ISR4351) with E1, and the device is comunicated with CUCM through SIP trunk. The calls from IPPhones are coming to the device, but when te call is transferred to E1 through dial-peers, the call is not working. These are ...
Hello colleagues! Possibly after Firmware reset of С40 the microphone from the kit stopped working. We've tried another mic, cable, port - nothing is working. Another problem is that I have only remote access to the C40. Could you please tell m...
Hi all, CST-SX20N-K9 normal controlled by TRC6 only on a short distance (about 1-1.5 meters). At longer distance the SX20 is poorly controlled or completely out of control. SX20 has latest CE8 firmware version - 8.3.7 Does anyone have...
Dear Cisco Community, One of our customer has an issue with Jabber notification.After upgrading his jabber to the version 18.104.22.168119 Build 288119, he got an issue with the Email notification.Usually when he is in call, and someone is calling him in...