User is not able to login ccmadmin by name or ip on subscriber through ccmadministrator with the err...
User is not able to login ccmadmin by name or ip on subscriber through ccmadministrator with the error "DCD09400032: Domain version information could not be obtained. Master Admin and Domain Admin privileges are not available"
After upgrading the CallManager to 4.1(3), user is not able to login ccmadmin by name or ip on subscriber through ccmadministrator with the error "DCD09400032: Domain version information could not be obtained. Master Admin and Domain Admin privileges are not available", though user can login to both ccmadmin and dc directory on the publisher.
This problem occurs when there is a situation of password mismatch between the publisher and subscriber before an upgrade. During an upgrade of sub, an attempt to re-create the replication agreements is initiated. The script responsible for recreating the replication agreements is supplied with the Admin password by the sub. Since the sub and pub have different passwords, the password supplied by sub is incorrect and hence, the script fails to establish replication agreements. Due to this, the sub stops functioning at the end of the upgrade and displays the above mentioned error message.
This issue is documented in Cisco bug ID CSCsb05870 .
To resolve this issue :
1) Run ccmpwdchanger password in publisher to match the password of Directory Manager password in publisher 2) Run 'reconfig_cluster'.
Also make sure the host and LMhost files are updated on all of the servers.
hello, i am trying to determine if it is possible to upgrade both the 2 pri t1 modules on both my ISR's to 4 pri t1 modulesmy concern is this paticular model gateways cannot support 4 pri's At first glance it appears i have a free slot to ...
Good morning.I am trying to build an IPT network.However, due to lack of infrastructure, we want to separate IP Phone bands by adding secondary to the same Vlan.I have a question.An example is Vlan 10.Existing data traffic is also Vlan 10, and IP is added...
Hello all, a dumb question, but just to be safe.I log in to UCCX (2 nodes cluster - version 11) and get the message that the JTAPI client versions are inconsistent.I realize that I have to do the resync on both UCCX nodes and then restart the CCX eng...
Hi Community,I have a doubt, how would be the configuration of the Dial peer (pots) to connect to an analog trunk (Fxo) or an E1 link.The type of configuration is a Local Gateway with an Existing Unified CM Environment. (Co resident PSTN-Local Gateway)I s...